Engineering Design NIDisk Guia do Utilizador descarregar pdf (Página 27)

NIDisk User Guide

1. If the I/O device is not present or is not named "Dev1", NIDisk issues the following

message:

If the device is not present, install it as described in Appendix C of the SIGNAL

Reference Guide. If it is present, open Measurement & Automation Explorer (MAX)

as described under "Confirm and troubleshoot I/O card and driver installation" in

Appendix C and verify that the device is named "Dev1" (see figure). If not, R-click

and rename.

2. If the I/O device is present but NIDisk does not recognize it, NIDisk issues the

following message:

Removable I/O devices, such as PCMCIA cards and USB units, usually need to be

removed and reinserted after the system is restored from Standby, even though

Device Manager may report the device as installed and "working properly". If

the I/O device is removable, remove and reinsert the device. If NIDisk still does not

recognize the device, proceed to step 4.

3. If NIDisk recognizes the I/O device but will not perform I/O operations, select I/O |

Reset on the menu to reset NIDisk status. See "I/O Reset". If NIDisk still will not

perform I/O operations, proceed to the next step.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 35 36

Sem comentários

Engineering Design NIDisk Guia do Utilizador Página 27